The Skaarhoj I/O¹ module acts as a gateway between the XC8 controller and the modules required to setup a professional slomo/replay system. Right click the module to open its popup menu. The following additional menu entries are available.


Off

Switches all connected Slomo modules off. Note SSD drives can handle a limited amount of write cycles so always switch off your replay system (or use this option) when not used to reduce wear of your drives.  


Bus

Optionally select the switcher bus to allow multiplexing of and transition between camera angles. Typically a MIX bus will be used for this, but on dedicated systems the Program bus can be used as well. Add a MIX bus to your profile and select it here. The bus will be automatically be programmed and can be ignored and (optionally) minimised.


Guardband

When possible, clips are saved with an additional amount of recording before and after the intended clip. The amount of seconds of this guardband is set here.


Mode

Select the controller mode, i.e. the number of output channels per camera angle and the manner in which the XC8 controls them.


¹ Available upon request.